BUGA Community

Hi guys I am in the middle getting a few rattles out of the front doors Have been to clark rubber & checked out all there bailey channel & could only find the right width but it isnt the same depth Has anyone else had this problem & where did you get yours I dont think it's possable to get the very top one as it is about 40mm deep & must be special

Thanks for that Warren Bloddy hell Im all embarassed now but you done well photos are good & I hope I have explained the steps clear enough for others to follow if not all they have to do is ask & I will help all I can Thanks again for all the time you spend keeping this GREAT webbsite in top form Cheers Reid

Hi guyes thought Id give you's an update on my camper as you saw in my gallery the rust was cut out under the pedals &the floor was painted I have moved 1 window back & panneld 2 off the seat bases were cut down 2 inches & the mew seats fitted I speuced up the dash a little so the cockpit is done the ply has been cut in for the floor so I can work off it to do the roof As you can see in the new lot of photos in my gallery I have taken the pop top off to check under for rust Just as well as a few small spots had started I have cleand up the gutters also that rubbery stuff they put it togeather with seames to shrink away from the metal & the moisture gets in & the rust starts You's all should check this out this seems to be the beddie's worst spot for rust so get into it now before it's too late By the way did you notice I can get it into the shed now just as well take the roof off & it bloddy rains Cheers Reid

Hi Eddy glad you liked the fitout in my old coaster yeah the table does fit between the seats to form another bed tho we never used it & it slid into brackets behind the pass seat when not in use I have other photos of the interior if you would like to see them Cheers Reid