BUGA Community

Classifieds => Wanted => Topic started by: Floatncoffee on September 17, 2013, 01:06:56 PM

Title: Drivers side window
Post by: Floatncoffee on September 17, 2013, 01:06:56 PM

Drivers side window wanted for 77 LWB...
SE Vic preferably
Cheers

Title: Re: Drivers side window
Post by: BeerBeddy on September 19, 2013, 03:22:07 PM

If they are the same as SWB I have one in Geelong.

Beerbeddy

Title: Re: Drivers side window
Post by: vuuup on September 19, 2013, 07:22:52 PM

i believe they are the same as i have one in my lwb

Title: Re: Drivers side window
Post by: BusyKiwi on September 19, 2013, 07:30:08 PM

swb and lwb are the same

left and right are the same, just the bottom channel is opposite

Title: Re: Drivers side window
Post by: ben on September 26, 2013, 06:30:28 AM

can you swap them over busy?

ben

Title: Re: Drivers side window
Post by: BusyKiwi on September 26, 2013, 07:49:27 AM

Sure can, use a rubber mallet and carefully bang it straight down and install by tapping on with rubber mallet. Don't place top of window on ground (concrete, steel) or any solid surface, across a bench is best.

Also be sure to measure and mark them, because if they are over one way to far the wheel will keep popping out.

It has a rubber material behind the steel plate, this is what keeps it on, ideally use the rubber again but if you can't then you can use a urethane but glass and channel has to be super clean

Title: Re: Drivers side window
Post by: Floatncoffee on October 06, 2013, 06:12:08 AM

Does that mean the glass is flat?

Title: Re: Drivers side window
Post by: Marishka on October 06, 2013, 06:17:16 AM

Yes

Title: Re: Drivers side window
Post by: BeerBeddy on October 06, 2013, 04:00:26 PM

Like the earth?

Title: Re: Drivers side window
Post by: Bas / NZ on October 06, 2013, 05:55:02 PM

what on earth are you talking about... ;)

Title: Re: Drivers side window
Post by: Marishka on October 07, 2013, 01:28:29 AM

There,s a bear in there.

Title: Re: Drivers side window
Post by: Floatncoffee on October 22, 2013, 04:19:07 PM

So as long as you have the rail, you could get a new one laser cut?

Title: Re: Drivers side window
Post by: BusyKiwi on October 22, 2013, 04:46:10 PM

you could get one cut but then you'd have to get it toughened. They don't break very easily so should be heaps floating around